Pilot's Guide
Table Of Contents
- Section 1 System Overview
- Section 2 Flight Instruments
- Section 3 Engine Indication System (EIS)
- Section 4 Audio Panel and CNS
- Section 5 Flight Management
- 5.1 Introduction
- 5.2 Using Map Displays
- 5.3 Waypoints
- 5.4 Airspaces
- 5.5 Direct-to-Navigation
- 5.6 Flight Planning
- Flight Plan Creation
- Adding Waypoints to an Existing Flight Plan
- Adding Airways to a Flight Plan
- Adding Procedures to a Stored Flight Plan
- Flight Plan Storage
- Flight Plan Editing
- Along Track Offsets
- Parallel Track
- Activating a Flight Plan Leg
- Inverting a Flight Plan
- Flight Plan Views
- Closest Point of FPL
- User-Defined Holding Patterns
- 5.7 Vertical Navigation
- 5.8 Procedures
- 5.9 Trip Planning
- 5.10 RAIM Prediction
- 5.11 Navigating a Flight Plan
- 5.12 Abnormal Operation
- Section 6 Hazard Avoidance
- Section 7 Automatic Flight Control System
- Section 8 Additional Features
- 8.1 Synthetic Vision Technology (SVT) (Optional)
- 8.2 SafeTaxi
- 8.3 ChartView (Optional)
- 8.4 FliteCharts
- 8.5 Airport Directory
- 8.6 Satellite Telephone Services
- 8.7 SiriusXM Satellite Radio (Service Optional)
- 8.8 Scheduler
- 8.9 Electronic Checklists
- 8.10 Flight Data Logging
- 8.11 Auxiliary Video (Optional)
- 8.12 Abnormal Operation
- Appendices
- Index
Garmin G1000 Pilot’s Guide for Cessna Nav III
190-00498-08 Rev. A
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
368
HAZARD AVOIDANCE
The following options are available (Figure 6-112):
• STRMSCP LTNG – Turns the display of Stormscope data on or off.
• STRMSCP MODE – Selects the CELL or STRIKE mode of lightning activity. Cell mode identifies clusters or
cells of electrical activity. Strike mode indicates the approximate location of lightning strikes.
• STRMSCP SMBL – Selects the range at which Stormscope data displays. Stormscope data is removed when
a map range greater than the STRMSCP SMBL value is selected.
Figure 6-111 Page Menu
Figure 6-112 Map Setup Menu