Pilot's Guide
Table Of Contents
- Section 1 System Overview
- Section 2 Flight Instruments
- Section 3 Engine Indication System (EIS)
- Section 4 Audio Panel and CNS
- Section 5 Flight Management
- 5.1 Introduction
- 5.2 Using Map Displays
- 5.3 Waypoints
- 5.4 Airspaces
- 5.5 Direct-to-Navigation
- 5.6 Flight Planning
- Flight Plan Creation
- Adding Waypoints to an Existing Flight Plan
- Adding Airways to a Flight Plan
- Adding Procedures to a Stored Flight Plan
- Flight Plan Storage
- Flight Plan Editing
- Along Track Offsets
- Parallel Track
- Activating a Flight Plan Leg
- Inverting a Flight Plan
- Flight Plan Views
- Closest Point of FPL
- User-Defined Holding Patterns
- 5.7 Vertical Navigation
- 5.8 Procedures
- 5.9 Trip Planning
- 5.10 RAIM Prediction
- 5.11 Navigating a Flight Plan
- 5.12 Abnormal Operation
- Section 6 Hazard Avoidance
- Section 7 Automatic Flight Control System
- Section 8 Additional Features
- 8.1 Synthetic Vision Technology (SVT) (Optional)
- 8.2 SafeTaxi
- 8.3 ChartView (Optional)
- 8.4 FliteCharts
- 8.5 Airport Directory
- 8.6 Satellite Telephone Services
- 8.7 SiriusXM Satellite Radio (Service Optional)
- 8.8 Scheduler
- 8.9 Electronic Checklists
- 8.10 Flight Data Logging
- 8.11 Auxiliary Video (Optional)
- 8.12 Abnormal Operation
- Appendices
- Index
Garmin G1000 Pilot’s Guide for Cessna Nav III
190-00498-08 Rev. Aii
WARNINGS, CAUTIONS, AND NOTES
WARNING: Navigation and terrain separation must NOT be predicated upon the use of the terrain avoidance
feature. The terrain avoidance feature is NOT intended to be used as a primary reference for terrain avoidance
and does not relieve the pilot from the responsibility of being aware of surroundings during flight. The
terrain avoidance feature is only to be used as an aid for terrain avoidance. Terrain data is obtained from
third party sources. Garmin is not able to independently verify the accuracy of the terrain data.
WARNING: The displayed minimum safe altitudes (MSAs) are only advisory in nature and should not be
relied upon as the sole source of obstacle and terrain avoidance information. Always refer to current
aeronautical charts for appropriate minimum clearance altitudes.
WARNING: Do not use outdated database information. Databases used in the G1000 system must be updated
regularly in order to ensure that the information remains current. Pilots using any outdated database do so
entirely at their own risk.
WARNING: Do not use basemap (land and water data) information for primary navigation. Basemap data is
intended only to supplement other approved navigation data sources and should be considered as an aid to
enhance situational awareness.
WARNING: Traffic information shown on system displays is provided as an aid in visually acquiring traffic.
Pilots must maneuver the aircraft based only upon ATC guidance or positive visual acquisition of conflicting
traffic.
WARNING: Use of the Stormscope is not intended for hazardous weather penetration (thunderstorm
penetration). Stormscope information, as displayed on the G1000 MFD, is to be used only for weather
avoidance, not penetration.
WARNING
:
Do not use data link weather information for maneuvering in, near, or around areas of hazardous
weather. Information contained within data link weather products may not accurately depict current
weather conditions.
WARNING
:
Do not use the indicated data link weather product age to determine the age of the weather
information shown by the data link weather product. Due to time delays inherent in gathering and processing
weather data for data link transmission, the weather information shown by the data link weather product
may be significantly older than the indicated weather product age.
WARNING:
For safety reasons, G1000 operational procedures must be learned on the ground.