Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-12 Rev. A
13-22
SECTION 13 – ANNUNCIATIONS
& ALERTS
GIA 63W Message Advisories (Cont.)
Message Comments
NAV1 RMT XFR – NAV1 remote
transfer key is stuck.
The remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or
“pressed”) state. Press the transfer switch again to cycle its operation. If the
problem persists, the system should be serviced.
NAV2 RMT XFR – NAV2 remote
transfer key is stuck.
G/S1 FAIL – G/S1 is inoperative.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The system
should be serviced.
G/S2 FAIL – G/S2 is inoperative.
G/S1 SERVICE – G/S1 needs
service. Return unit for repair.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The receiver
may still be available. The system should be serviced when possible.
G/S2 SERVICE – G/S2 needs
service. Return unit for repair.
FAILED PATH – A data path has
failed.
A data path connected to the GDU or the GIA 63/W has failed.
GEA 71 Message Advisories
Message Comments
GEA1 CONFIG – GEA1 config error.
Config service req’d.
The GEA1 configuration settings do not match those of backup configuration
memory. The G1000 system should be serviced.
MANIFEST – GEA1 software
mismatch, communication halted.
The #1 GEA 71 has incorrect software installed. The G1000 system should be
serviced.
GSR 56 Message Advisories
Message Comments
GSR1 FAIL – GSR1 has failed. A failure has been detected in the #1 GSR 56. The system should be serviced.
GDC 74A Message Advisories
Message Comments
ADC1 ALT EC – ADC1 altitude error
correction is unavailable.
GDC1 is reporting that the altitude error correction is unavailable.
ADC1 AS EC – ADC1 airspeed error
correction is unavailable.
GDC1 is reporting that the airspeed error correction is unavailable.
MANIFEST – GDC1 software
mismatch, communication halted.
The GDC 74A has incorrect software installed. The G1000 system should be
serviced.