Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-12 Rev. A
1-8
SECTION 1
SYSTEM OVERVIEW
XPDR – Press to display the transponder mode
selection softkeys.
STBY – Press to select Standby Mode.
ON – Press to select Mode A.
ALT – Press to select Altitude Reporting Mode.
GND – Press to select Ground Mode.
VFR – Press to automatically squawk 1200 (only
in the U.S.A., refer to ICAO standards for VFR
codes in other countries).
CODE – Press to display transponder code selection
softkeys 0-7.
0 through 7 – Press numbers to enter code or
use the small FMS knob to enter the first two
digits then turn the large FMS knob to move the
curser. Again using the small FMS knob enter
the second two digits.
IDENT – Press to provide special aircraft
position identification to Air Traffic Control
(ATC).
.
Press the BACK Softkey to return
to the top-level softkeys.
Press the BACK Softkey to return
to the previous softkey level.
ALERTS
ALERTS
DME
ALERTS
Figure 1-4 XPDR (Transponder) Softkeys
BKSP – Press to remove numbers entered one
at a time.
BACK – Press to return to the previous level
softkeys
IDENT – Press to provide special aircraft position
identification to Air Traffic Control (ATC).
BACK – Press to return to the previous level
softkeys.
ALERTS – Press to display the Alerts Window.
IDENT – Press to provide special aircraft position
identification to Air Traffic Control (ATC).
TMR/REF – Press to display the Timer/References
Window.
NRST – Press to display the Nearest Airports
Window.
ALERTS/ADVISORY – Press to display the Alerts/
Advisory Window.