Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-12 Rev. A
13-12
SECTION 13 – ANNUNCIATIONS
& ALERTS
13.9 G1000 SYSTEM MESSAGE ADVISORIES
This section describes various G1000 system message advisories. Certain messages are issued due to an LRU or an LRU
function failure. Such messages are normally accompanied by a corresponding red ‘X’ annunciation as shown previously in
the G1000 System Annunciation section.
NOTE: This section provides information regarding G1000 message advisories that may be displayed by the
system. Knowledge of the aircraft, systems, flight conditions, and other existing operational priorities must
be considered when responding to a message. Always use sound pilot judgment. The Cessna aircraft Pilot’s
Operating Handbook (POH) takes precedence over any conflicting guidance found in this section.
MFD & PFD Message Advisories
Message Comments
DATA LOST – Pilot stored data was
lost. Recheck settings.
The pilot profile data was lost. System reverts to default pilot profile and settings.
The pilot may reconfigure the MFD & PFDs with preferred settings, if desired.
XTALK ERROR – A flight display
crosstalk error has occurred.
The MFD and PFD are not communicating with each other. The system should be
serviced.
PFD1 SERVICE – PFD1 needs
service. Return unit for repair.
The PFD and/or MFD self-test has detected a problem. The system should be
serviced.
MFD1 SERVICE – MFD1 needs
service. Return unit for repair.
MANIFEST – PFD1 software
mismatch, communication halted.
The PFD and/or MFD has incorrect software installed. The system should be
serviced.
MANIFEST – MFD1 software
mismatch, communication halted.
PFD1 CONFIG – PFD1 config error.
Config service req’d.
The PFD configuration settings do not match backup configuration memory. The
system should be serviced.
MFD1 CONFIG – MFD1 config
error. Config service req’d.
The MFD configuration settings do not match backup configuration memory. The
system should be serviced.
SW MISMATCH – GDU software
version mismatch. Xtalk is off.
The MFD and PFD have different software versions installed. The system should be
serviced.
PFD1 COOLING – PFD1 has poor
cooling. Reducing power usage.
The PFD and/or MFD is overheating and is reducing power consumption by dimming
the display. If problem persists, the system should be serviced.
MFD1 COOLING – MFD1 has poor
cooling. Reducing power usage.