Cockpit Reference Guide
Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-12 Rev. A
SECTION 11 – ADDITIONAL
FEATURES
11-20
11.8 ELECTRONIC CHECKLISTS
NOTE: The checklists presented here are for
example only and may not reflect checklists actu-
ally available for the Cessna NAV III Aircraft. This
material is not intended to replace the checklist
information presented in the AFM or the Pilot
Safety and Warning Supplements document.
NOTE: Garmin is not responsible for the content
of checklists. Cessna NAV III Aircraft checklists
are created, modified, and updated by the aircraft
manufacturer.
The optional checklist functions are displayed on two
levels of softkeys that are available on any MFD page.
The MFD is able to display optional electronic check-
lists which allow a pilot to quickly find the proper proce-
dure on the ground and during each phase of flight. The
G1000 accesses the checklists from an SD card inserted
into the bezel slot. If the SD card contains an invalid
checklist file or no checklist, the Power-up Page messages
display ‘Checklist File: Invalid’ or ‘Checklist File: N/A’ (not
available) and the CHKLIST Softkey is not available.
Figure 11-31 Checklist Softkeys
CHKLIST
DCLTR
SYSTEM
MAP
The CHECK Softkey label changes to UNCHECK
when the checklist item is already checked.
EXIT CHECKSYSTEM EMERGCY
SHW CHRT
(Optional)
Accessing and navigating checklists:
1)
From any page on the MFD, press the CHKLIST
Softkey turn the large FMS Knob to select the
Checklist Page.
2)
Turn the large FMS Knob to select the ‘GROUP’
field.
3)
Turn the small FMS Knob to select the desired
procedure and press the ENT Key.
4)
Turn the large FMS Knob to select the ‘CHECKLIST’
field.
5)
Turn the FMS Knob to select the desired checklist
and press the ENT Key. The selected checklist item
is indicated with white text surrounded by a white
box.
6)
Press the ENT Key or CHECK Softkey to check the
selected checklist item. The line item turns green and
a checkmark is placed in the associated box. The next
line item is automatically selected for checking.
Either FMS Knob can be used to scroll through the
checklist and select the desired checklist item.
Press the CLR Key or UNCHECK Softkey to remove
a check mark from an item.