Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-12 Rev. A
10-25
SECTION 10 – HAZARD
AVOIDANCE
Displaying Traffic on the Navigation Map
1) Ensure TIS is operating. With the Navigation Map
displayed, press the MAP Softkey.
2) Press the TRAFFIC Softkey. Traffic is now displayed
on the map.
Switching from operating mode to standby
mode:
On the Traffic Page, press the STANDBY Softkey
Or:
1) Press the MENU Key and turn the small FMS knob
to select ‘Standby Mode’.
2) Press the ENT Key.
altituDe Display
The pilot can select the volume of airspace in which
non-threat and proximity traffic is displayed. TAs occur-
ring outside of these limits will always be shown.
Changing the altitude range:
1) On the Traffic Map Page, press the ALT MODE
Softkey.
2) Press one of the following Softkeys:
 • ABOVE: Displays non-threat and proximity
traffic from 9000 feet above the aircraft to 2700
feet below the aircraft. Typically used during climb
phase of flight.
 • NORMAL: Displays non-threat and proximity
traffic from 2700 feet above the aircraft to 2700
feet below the aircraft. Typically used during
enroute phase of flight.
 • BELOW: Displays non-threat and proximity traffic
from 2700 feet above the aircraft to 9000 feet
below the aircraft. Typically used during descent
phase of flight.
• U NREST (unrestricted): All traffic is displayed from
9900 feet above and 9900 feet below the aircraft.
3) To return to the Traffic Map Page, press the BACK
Softkey.
Or :
1) Press the MENU Key.
2) Turn the small FMS Knob to select one of the
following (see Softkey description in previous step
 • ABOVE
 • NORMAL
 • BELOW
 • UNRESTRICTED
3) Press the ENT Key.
Flight ID Display
The Flight IDs of other aircraft (when available) can
be enabled for display on the Traffic Map Page. When a
flight ID is received, it will appear above or below the cor-
responding traffic symbol on the Traffic Map Page when
this option is enabled.
Enabling/Disabling Flight ID Display:
On the Traffic Map Page, press the FLT ID Softkey.
Or :
1) Press the MENU Key.
2) Turn the small FMS Knob to select ‘Show Flight IDs’
or ‘Hide Flight IDs’ (choice dependent on current
state) (Figure 6-92).
3) Press the ENT Key.