Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-12 Rev. A
8-2
SECTION 8 – FLIGHT PLANNING
6) Turn the small FMS Knob to select RAD/RAD (radial/
radial).
7) Press the ENT Key.
8) The cursor moves to the ‘REFERENCE WAYPOINTS’
field. With the first waypoint name highlighted, use
the FMS Knobs to enter the desired waypoint name.
Waypoints may also be selected as follows:
a) When a flight plan is active, turning the small
FMS Knob to the left will display a list of the
flight plan waypoints.
b) Turn the large FMS Knob to select the desired
waypoint.
c) Press the ENT Key.
Or:
a) Turn the small FMS Knob to the left. Initially, a
flight plan waypoint list is displayed.
b) Turn the small FMS Knob to the right to dis-
play the ‘NRST’ airports to the aircraft’s current
position.
c) Turn the large FMS Knob to select the desired
waypoint.
d) Press the ENT Key.
Or:
a) Turn the small FMS Knob to the left. Initially, a
flight plan waypoint list is displayed.
b) Turn the small FMS Knob to the right to dis-
play the ‘RECENT’ waypoints.
c) Turn the large FMS Knob to select the desired
waypoint.
d) Press the ENT Key.
Or:
a) Turn the small FMS Knob to the left. Initially, a
flight plan waypoint list is displayed.
b) Turn the small FMS Knob to the right to dis-
play the ‘USER’ waypoints.
c) Turn the large FMS Knob to select the desired
waypoint.
d) Press the ENT Key.
9) Press the ENT Key. The cursor is displayed in the
‘RAD’ (radial) field. Enter the desired radial from
the reference waypoint.
10) Press the ENT Key.
11) Repeat step 10 to enter the next waypoint name.
12) Press the ENT Key. The cursor is displayed in the
‘RAD’ (radial) field for the second waypoint. Enter
the desired radial from the reference waypoint.
13) Press the ENT Key.
14) Press the FMS Knob to remove the flashing
cursor.
Create a User Waypoint Defined by a Radial &
Distance from Another Waypoint
1) With the User Defined Waypoint Page displayed,
press the NEW Softkey. A waypoint is created at
the current aircraft position.
2) Enter the desired waypoint name.
3) Press the ENT Key.
4) The cursor is now in the ‘WAYPOINT TYPE’ field.
If desired, the waypoint can be made temporary
(deleted automatically when the system is turned
off). If the waypoint is to remain in the system,
proceed to step 7.
a) Turn the large FMS Knob one click to the left
to highlight ‘TEMPORARY’.
b) Press the ENT Key to place a check-mark in
the box. Turn the large FMS Knob to place the
cursor back in the ‘WAYPOINT TYPE’ field.
5) With the cursor in the ‘WAYPOINT TYPE’ field, turn
the small FMS Knob to display a list of waypoint
types.