Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-09 Rev. A
SECTION 11 – ADDITIONAL
FEATURES
11-20
11.7 ELECTRONIC CHECKLISTS
NOTE: The checklists presented here are for
example only and may not reflect checklists actu-
ally available for the Cessna NAV III Aircraft. This
material is not intended to replace the checklist
information presented in the AFM or the Pilot
Safety and Warning Supplements document.
NOTE: Garmin is not responsible for the content
of checklists. Cessna NAV III Aircraft checklists
are created, modified, and updated by the aircraft
manufacturer.
The optional checklist functions are displayed on two
levels of softkeys that are available on any MFD page.
The MFD is able to display optional electronic checklists
which allow a pilot to quickly find the proper procedure
on the ground and during each phase of flight. The G1000
accesses the checklists from an SD card inserted into the
bezel slot. If the SD card contains an invalid checklist
file or no checklist, the Power-up Page messages display
Invalid Checklist File or Checklist File Not Present and
the CHKLIST Softkey is not available.
Figure 11-30 Checklist Softkeys
CHKLIST
DCLTR
SYSTEM
MAP
The DONE Softkey label changes to UNDO
when the checklist item is already checked.
EXITDONESYSTEM EMERGCY
SHW CHRT
(Optional)
Accessing and navigating checklists:
1) From any page on the MFD, press the CHKLIST
Softkey.
2) Turn the large FMS Knob to select the GROUP
field.
3) Turn the small FMS Knob to select the desired
procedure and press the ENT Key.
4) Turn the large FMS Knob to select the Checklist
field.
5) Turn the FMS Knob to select the desired checklist
and press the ENT Key.
6) Turn the FMS Knob to scroll through the checklist
and highlight the desired checklist item. A hollow
white box is used for the checkmark.
The following colors are used for checklist items:
•Blue-Itemshasnotbeenhighlighted
•White-Itemishighlightedforselection
•Green-Itemhasbeenselected
•Yellow-Warningnotes
7) Press the ENT Key or DONE Softkey to check the
highlighted checklist item. The line item turns green
and a checkmark is placed in the box next to it.
The next line item is automatically highlighted for
checking.
Press the CLR Key to remove a check mark from
an item.