Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-09 Rev. A
SECTION 7 – NAVIGATION
7-23
4) Turn the large FMS Knob to select the desired
airport.
5) Press the ENT Key.
Select a Recently Entered Airport Identifier
1) With the Airport Information Page displayed, press
the FMS Knob to activate the cursor.
2) Turn the small FMS Knob to the left. Initially, a flight
plan waypoint list is displayed as in Figure 7-54.
The list is populated only when navigating a flight
plan.
3) Turn the small FMS Knob to the right to display the
‘RECENT’ airports as shown in Figure 7-56.
Figure 7-56 Recently Entered Airports List
4) Turn the large FMS Knob to select the desired
airport.
5) Press the ENT Key.
Select an Airport by Facility Name or City
Location
1) With the Airport Information Page displayed, press
the FMS Knob to activate the cursor.
2) Turn the large FMS Knob to the right to select the
facility name or location (city) field.
3) Enter the desired facility name or city.
5) Press the ENT Key. If there are duplicate names
in the database, a list is displayed from which to
choose the desired location.
6) To remove the flashing cursor, press the FMS
Knob.
Access Runway Information
1) With the Airport Information Page displayed, press
the FMS Knob to activate the cursor.
2) Turn the large FMS Knob to place the cursor on the
‘RUNWAYS’ identifier field.
3) Turn the small FMS Knob in the direction of the
green arrow to display the next runway for the
selected airport. Continue turning the small FMS
Knob to select the desired runway.
4) To remove the flashing cursor, press the FMS
Knob.
Access Frequency Information
1) With the Airport Information Page displayed, press
the FMS Knob to activate the cursor.
2) Turn the large FMS Knob to move the cursor to the
Frequencies box.
3) Turn either FMS Knob to scroll through the list,
placing the cursor on the desired frequency. If a
listed frequency has sector or altitude restrictions,
the frequency is preceded by an info (‘i’) designation.
Press the ENT Key to view the information. The
following may be displayed with the frequency:
 • ‘TX’ – transmit only
 • ‘RX’–receiveonly
 • ‘PT’–parttimefrequency
4) Press the ENT Key to place the selected frequency
in the standby field of the COM or NAV box.
5) To remove the cursor, press the FMS Knob.