Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-08 Rev. A
SECTION 6 – AUTOMATIC
FLIGHT CONTROL
6-25
Departure
Climbing to the Selected Altitude and flying
an assigned heading:
1) Use the ALT Knob to set the Selected Altitude to
12,000 feet after takeoff. Depart KMKC:
2) In this example, Vertical Speed Mode is used to
capture the Selected Altitude (Pitch Hold, Vertical
Speed, or Flight Level Change Mode may be
used).
a) Adjust the aircraft’s vertical speed to the desired
1,000 fpm.
b) Press the
VS Key to activate Vertical Speed and
Roll Hold modes and arm Selected Altitude
Capture Mode.
The Vertical Speed Reference may be adjusted
after Vertical Speed Mode is selected using the
NOSE UP/DN Key or pushing the
CWS Button
while hand-flying the aircraft to establish a new
Vertical Speed Reference.
Figure 6-31 Departure
Selected Altitude of 12,000 MSL
1
2
3
4
HDG Mode
VS
M
ode
ALT Mode
TO
Mo
d
e
KMKC
c) Press the AP Key to engage the autopilot in a
climb using Vertical Speed Mode.
3) Press the HDG Key to activate Heading Select Mode
while the autopilot is engaged in the climb.
Use the HDG Knob to set the Selected Heading,
complying with ATC vectors to intercept Airway
V4. The autopilot follows the Selected Heading
Bug on the HSI and turns the aircraft to the desired
heading.
4) As the aircraft nears the Selected Altitude, the flight
director transitions to Selected Altitude Capture
Mode, indicated by the green ‘ALTS’ annunciation
flashing for up to 10 seconds.
At 50 feet from the Selected Altitude, the green
‘ALT’ annunciation flashes for up to 10 seconds;
the autopilot transitions to Altitude Hold Mode and
levels the aircraft.