Cockpit Reference Guide
Table Of Contents
- Section 1: System Overview
- Section 2: Flight Instruments
- Section 3: Engine Indication System (EIS)
- Section 4: NAV/COM and Transponder
- Section 5: Audio Panel
- Section 6: Automatic Flight Control
- Section 7: Navigation
- 7.1 Navigation Map Page
- 7.2 Direct-to Navigation
- 7.3 Navigating an Example Flight Plan
- 7.4 Airport Information
- 7.5 Intersection Information
- 7.6 NDB Information
- 7.7 VOR Information
- 7.8 User Waypoint Information Page
- 7.9 Nearest Airports
- 7.10 Nearest Intersections
- 7.11 Nearest NDB
- 7.12 Nearest VOR
- 7.13 Nearest User Waypoint
- 7.14 Nearest Frequencies
- 7.15 Nearest Airspaces
- Section 8: Flight Planning
- 8.1 User Defined Waypoints
- 8.2 Viewing the Active Flight Plan
- 8.3 Activate a Stored Flight Plan
- 8.4 Activate a Flight Plan Leg
- 8.5 Stop Navigating a Flight Plan
- 8.6 Invert Active Flight Plan
- 8.7 Create a New Flight Plan
- 8.8 Enter an Airway in a Flight Plan
- 8.9 Load a Departure
- 8.10 Load an Arrival
- 8.11 Load an Approach
- 8.12 Remove a Departure, Arrival, Approach, or Airway from a Flight Plan
- 8.13 Store a Flight Plan
- 8.14 Edit a Stored Flight Plan
- 8.15 Delete a Waypoint from the Flight Plan
- 8.16 Invert and Activate a Stored Flight Plan
- 8.17 Copy a Flight Plan
- 8.18 Delete a Flight Plan
- 8.19 Graphical Flight Plan Creation
- 8.20 Trip Planning
- Section 9: Procedures
- Section 10: Hazard Avoidance
- 10.1 Customizing the Hazard Displays on the Navigation Map
- 10.2 STORMSCOPE® (Optional)
- 10.3 XM Weather (Service Optional)
- 10.4 Traffic Systems
- 10.5 Terrain and Obstacle Proximity
- 10.6 Terrain Awareness & Warning System (TAWS) Display (Optional)
- Displaying Terrain on the TAWS Page
- Enable/Disable Aviation Data
- TAWS Inhibit
- Manual System Test
- Forward Looking Terrain Avoidance (FLTA)
- Premature Descent Alert (PDA)
- Excessive Descent Rate Alert (EDR)
- Negative Climb Rate After TakeoffAlert (NCR)
- “Five-Hundred” Aural Alert
- Displaying Terrain and Obstacles on the Navigation Map
- Pop-up Alerts
- TAWS Alerts Summary
- Alert Annunciations
- Section 11: Abnormal Operation
- Section 12: Annunciations & Alerts
- 12.1 Alert Level Definitions
- 12.2 NAV III Aircraft Alerts
- 12.3 CO Guardian Messages
- 12.4 AFCS Alerts
- 12.5 TAWS Alerts
- 12.6 Other G1000 Aural Alerts
- 12.7 G1000 System Annunciations
- 12.8 G1000 System Message Advisories
- MFD & PFD Message Advisories
- Database Message Advisories
- GMA 1347 Message Advisories
- GIA 63 Message Advisories
- GIA 63W Message Advisories
- GEA 71 Message Advisories
- GTX 33 Message Advisories
- GRS 77 Message Advisories
- GMU 44 Message Advisories
- GDL 69A Message Advisories
- GDC 74A Message Advisories
- Miscellaneous Message Advisories
- Index
Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-08 Rev. A
SECTION 3 – ENGINE
INDICATION SYSTEM (EIS)
3-4
3.2 LEAN DISPLAY
NOTE: The pilot should follow the engine man-
ufacturer’s recommended leaning procedures in
the Pilot’s Operating Handbook (POH).
1
Engine Manifold Pressure Gauge (MAN IN)
Models 182T, T182T, 206H, T206H – Displays
engine power in inches of mercury (in Hg).
Turbocharged aircraft have a red portion of the
gauge indicating the maximum manifold pressure
range. A white tick mark is displayed indicating
the cruise manifold pressure (Model T182 only).
2
Tachometer (RPM) – Shows propeller speeds
in revolutions per minute (rpm). Red range
indicates propeller overspeed warning; a white
high-rpm range indicates above normal operating
speeds (Models 172S, 206H and T206H).
3
Fuel Flow (FFLOW GPH) – Shows the current
fuel flow in gallons per hour (gph).
4
Turbine Inlet Temperature Indicator
(TIT) Models T182T and T206H – Displays
the temperature at the turbine inlet in degrees
Fahrenheit (°F). When the ASSIST Softkey is
pressed, the TIT deviation from peak (∆PEAK) is
displayed below the indicator.
5
Exhaust Gas Temperature Bar Graph (EGT
°F) – Displays the exhaust gas temperature of all
cylinders in degrees Fahrenheit (°F); a readout
for the selected cylinder (by default, the hottest
cylinder) is shown below the bar graph. The
selected cylinder is indicated in light blue.
Cylinders whose EGTs are in the normal range
appear in white. Pressing the ASSIST Softkey
causes the EGT deviation from peak (∆PEAK)
for the selected cylinder to be displayed below
the indicator.
6
Cylinder Head Temperature Indicator (CHT)
– Shows the head temperatures of all cylinders
in degrees Fahrenheit (°F); a readout for the
selected cylinder (by default, the hottest cylinder)
is shown below the bar graph. The selected
cylinder is indicated in light blue. Cylinders
whose CHTs are in the normal range appear in
white. Cylinders whose CHTs enter the caution
and warning ranges appear in yellow and red,
respectively.
7
Fuel Quantity Indicator (FUEL QTY GAL)
– Shows the quantity of fuel in the left and right
fuel tanks (left–L and right–R). When full, the
indicator displays to 35 gallons per side (26
gallons for the Models 172R and 172S).