Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-08 Rev. A
12-18
SECTION 12 – ANNUNCIATIONS
& ALERTS
GIA 63W Message Advisories (Cont.)
Message Comments
GPS1 SERVICE – GPS1 needs service.
Return unit for repair.
A failure has been detected in the GPS1 and/or GPS2 receiver. The receiver may
still be available. The G1000 system should be serviced.
GPS2 SERVICE – GPS2 needs service.
Return unit for repair.
NAV1 SERVICE – NAV1 needs service.
Return unit for repair.
A failure has been detected in the NAV1 and/or NAV2 receiver. The receiver may
still be available. The G1000 system should be serviced.
NAV2 SERVICE – NAV2 needs service.
Return unit for repair.
NAV1 RMT XFR – NAV1 remote
transfer key is stuck.
The remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or
“pressed”) state. Press the transfer switch again to cycle its operation. If the
problem persists, the G1000 system should be serviced.
NAV2 RMT XFR – NAV2 remote
transfer key is stuck.
G/S1 FAIL – G/S1 is inoperative.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The
G1000 system should be serviced.
G/S2 FAIL – G/S2 is inoperative.
G/S1 SERVICE – G/S1 needs service.
Return unit for repair.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The
receiver may still be available. The G1000 system should be serviced when
possible.
G/S2 SERVICE – G/S2 needs service.
Return unit for repair.
GEA 71 Message Advisories
Message Comments
GEA1 CONFIG – GEA1 configuration
error. Config service req’d.
The GEA1 configuration settings do not match those of backup configuration
memory. The G1000 system should be serviced.
MANIFEST – GEA1 software
mismatch, communication halted.
The #1 GEA 71 has incorrect software installed. The G1000 system should be
serviced.