Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-08 Rev. A
9-3
SECTION 9 – PROCEDURES
Load and/or Activate an Approach Procedure
1) Press the PROC Key.
2) Turn the large FMS Knob to highlight ‘SELECT
APPROACH’.
3) Press the ENT Key.
4) If a flight plan is active, the destination airport
is displayed as the default. A list of available
approaches is also displayed. If no flight plan is
active, use the
FMS Knobs to enter the identifier of
the desired airport. Press the
ENT Key.
5) Turn the large FMS Knob to highlight the Approach
field. Turn the small
FMS Knob to display a list of
available approaches.
Figure 9-6 Selecting an Approach Procedure
6) Turn either FMS Knob to highlight the desired
approach. Press the
ENT Key.
7) The cursor moves to the TRANSITIONS field. Turn
the large
FMS Knob to highlight the desired
transition waypoint and press the
ENT Key. (The
“Vectors” option assumes vectors will be received
to the final course segment of the approach and
will provide navigation guidance relative to the final
approach course.)
Figure 9-7 Selecting an Approach Transition
8) Turn the large FMS Knob to highlight ‘Activate?’
and press the
ENT Key to activate the approach.
Activating the approach initiates a direct-to for
IAF and the G1000 immediately begins navigating
to the IAF. Selecting ‘Load?’ adds the procedure
to the flight plan without immediately using it for
navigation guidance.
Activate An Approach in the Active Flight Plan
1) With the Navigation Map Page displayed, press the
PROC Key.
2) Turn the large FMS Knob to highlight ‘ACTIVATE
APPROACH’.
3) Press the ENT Key. The approach procedure is now
active and a direct-to is initiated to the IAF.