Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-08 Rev. A
9-1
SECTION 9 – PROCEDURES
SECTION 9: PROCEDURES
9.1 ARRIVALS AND DEPARTURES
Load and Activate a Departure Procedure
1) Press the PROC Key.
2) Turn the large FMS Knob to highlight ‘SELECT
DEPARTURE’.
3) Press the ENT Key.
4) If a flight plan is active, the departure airport
is displayed as the default. A list of available
departures is also displayed. If no flight plan is
active, use the
FMS Knobs to enter the identifier
of the desired airport. Press the
ENT Key.
5) Turn the large FMS Knob to highlight the Departure
field. Turn the small
FMS Knob to display a list of
available departures.
6) Turn either FMS Knob to select the desired departure
and press the ENT Key.
Figure 9-1 Select Departure
7) A list of runways may be displayed for the departure.
Turn either
FMS Knob to select the desired runway
and press the ENT Key.
8) A list of available transitions is displayed for the
departure. Turn either
FMS Knob to highlight the
desired transition waypoint and press the
ENT
Key.
Figure 9-2 Select Departure Transition
9) With ‘LOAD?’ highlighted, press the ENT Key. The
departure is active when the flight plan is active.
Load and Activate An Arrival Procedure
NOTE: If any portion of an arrival procedure is
the active leg of a flight plan, the existing arrival
procedure must be deleted before changing to a
different arrival procedure.
1) Press the PROC Key.
2) Turn the large FMS Knob to highlight ‘SELECT
ARRIVAL’.
3) Press the ENT Key.
4) If a flight plan is active, the destination airport is
displayed as the default. A list of available arrivals
is also displayed. If no flight plan is active, use the
FMS Knobs to enter the identifier of the desired
airport. Press the
ENT Key.
5) Turn the large FMS Knob to highlight the Arrival
field. Turn the small
FMS Knob to display a list of
available arrivals.
6) Turn either FMS Knob to select the desired arrival
and press the ENT Key.