Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
1-6
SECTION 1
SYSTEM OVERVIEW
Press the STD BARO or BACK Softkeys
to return to the top level softkeys
.
Press the DFLTS Softkey to change the PFD
metric values to standard.
Figure 1-4 PFD Softkey Flow Chart – 2
BRG2 (bearing) – Press to cycle through the
following Nav sources, making the pointer the
indicator for the corresponding source and
displaying the appropriate information.
NAV2 – Displays NAV2 waypoint frequency or
identifier and DME information in the BRG2
Information Window.
GPS – Displays GPS waypoint identifier and GPS
distance information in the BRG2 Information
Window.
ADF – Displays ADF in the BRG2 Information
Window.
OFF – Removes the BRG2 Information
Window.
STD BARO – Press to set the barometric pressure to
29.92 inches of mercury (1013 hPa by pressing
the METRIC Softkey).
BACK – Press to return to the previous level
softkeys.
ALERTS – Press to display the Alerts Window.
OBS – Press to select OBS mode on the CDI when
navigating by GPS (only available with active leg).
CDI – Press to change navigation mode on the CDI
between GPS, VOR1, and VOR2.
DME (optional) – Press to display the DME Tuning
Window.
XPDR – Press to display the transponder mode
selection softkeys.
STBY – Press to select standby mode.
ON – Press to select mode A.
ALT – Press to select altitude reporting mode.
GND – Press to select ground mode.
VFR – Press to automatically squawk 1200 (only
in the U.S.A., refer to ICAO standards for VFR
codes in other countries).
CODE – Press to display transponder code selection
softkeys 0-7.
0 through 7 – Press numbers to enter code.