Cockpit Reference Guide
Garmin G1000 Cockpit Reference Guide for the Quest KODIAK
™
100
190-00645-07 Rev. A 37
Flight Planning
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
CREATING A USER-DEFINED HOLD AT A DIRECT-TO WAYPOINT
1)
Press a Direct-to Key and set up the direct-to waypoint as desired, but
select ‘HOLD?’ instead of ‘ACTIVATE?’ when finished (MFD or PFD).
2)
Use the FMS Knobs to edit the entry course, and press the ENT Key.
3)
Use the small FMS Knob to select ‘INBOUND’ or ‘OUTBOUND’ course
direction, and press the ENT Key.
4)
Use the small FMS Knob to select ‘TIME’ or ‘DIST’ length mode, and press
the ENT Key.
5)
Use the FMS Knobs to edit the length, and press the ENT Key.
6)
Use the small FMS Knob to select ‘RIGHT’ or ‘LEFT’ turn direction, and
press the ENT Key.
7)
Use the FMS Knobs to edit the Expect Further Clearance Time (EFC TIME),
and press the ENT Key.
8)
Press the ENT Key while ‘ACTIVATE?’ is highlighted to activate the direct-to
with the user-defined hold defined at the direct-to waypoint. (If the direct-
to wayoint is part of the active flight plan, the HOLD is inserted into the
active flight plan. If the direct-to waypoint is not part of the active flight
plan, an off-route direct-to hold is created.
EXITING A USER-DEFINED HOLD INSERTED INTO THE ACTIVE FLIGHT PLAN
Press the SUSP Softkey. The system will provide guidance to follow the
holding pattern to the inbound course and resume automatic waypoint
sequencing.
REMOVING A USER-DEFINED HOLD INSERTED INTO THE ACTIVE FLIGHT PLAN
1)
Press the FPL Key to display the Active Flight Plan Page (MFD) or the Active
Flight Plan Window (PFD).
2)
Press the FMS Knob to activate the cursor (not required on the PFD) and
turn the large FMS Knob to highlight the HOLD waypoint.
3)
Press the CLR Key. A ‘Remove Holding Pattern?’ confirmation window is
displayed.
4)
Select ‘OK’ and press the ENT Key. The holding pattern is removed from
the active flight plan. Select ‘CANCEL’ and press the ENT Key to cancel the
removal of the holding pattern.