Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Quest KODIAK
™
100
190-00645-07 Rev. A 3
Flight Instruments
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
SYNCHRONIZING THE CDIS
1) Select the AUX - SYSTEM SETUP Page using the FMS Knob on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight CDI in SYNCHRONIZATION Window.
4) Turn the small FMS Knob clockwise to ON or counterclockwise to OFF.
CHANGING THE SELECTED GPS CDI SETTING
1) Use the FMS Knob to select the AUX - SYSTEM SETUP Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight Selected in the GPS CDI box.
4) Turn the small FMS Knob to highlight the desired setting and press the
ENT Key.
5) To cancel the selection, press the FMS Knob or the CLR Key.
CHANGE NAVIGATION SOURCES
1) Press the CDI Softkey to change from GPS to VOR1 or LOC1. This places
the cyan tuning box over the NAV1 standby frequency in the upper left
corner of the PFD.
2) Press the CDI Softkey again to change from VOR1 or LOC1 to VOR2 or
LOC2. This places the cyan tuning box over the NAV2 standby frequency.
3) Press the CDI Softkey a third time to return to GPS.
ENABLING/DISABLING OBS MODE WHILE NAVIGATING WITH GPS
1) Press the OBS Softkey to select OBS Mode.
2) Turn the CRS Knob to select the desired course to/from the waypoint. Press
a CRS Knob to synchronize the Selected Course with the bearing to the
next waypoint.
3) Press the OBS Softkey again to return to automatic waypoint sequencing.