Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Quest KODIAK
™
100
190-00645-07 Rev. A
Appendix
127
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
13) Turn system power OFF.
14) Remove the SD card from the top card slot of the MFD.
15) Turn system power ON.
16) Press the ENT Key to acknowledge the startup screen.
17) Turn the large FMS Knob to select the AUX Page group on the MFD.
18) Turn the small FMS Knob to select the System Status Page.
19) Press the Display Database Selection Softkey to show standby navigation
database information for each display (MFD1 DB, PFD1 DB, PFD2 DB).
Verify the correct standby navigation database cycle information is shown
for each display.
To Manually Activate the Standby Navigation Database:
1) From the AUX-SYSTEM STATUS Page, select the STANDBY DB Softkey.
2) A prompt similar to the following figure below is displayed. Select ‘Yes’
to overwrite the Active Navigation Database with the Standby Navigation
Database. Select ‘No’ to cancel.
Standby Nav Database Activation Confirmation Window
Loading the Magnetic Field Variation Database update:
A copy of the current magnetic field variation database (MV DB) is included with
the navigation database. At startup, the system compares this version of the MV
DB with that presently being used by each AHRS (GRS1 and GRS2). If the system
determines the MV DB needs to be updated, a prompt is displayed on the Navigation
Map Page, as shown in the following figure.