Pilot's Guide

190-00552-05 Rev. A
Garmin G1000 Pilot’s Guide for the Cessna Corvalis/Corvalis TT
63
FLIGHT INSTRUMENTS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
Whenabearingpointerisdisplayed,itsassociatedinformationwindowisalsodisplayed.TheBearing
Informationwindows(Figure2-22)aredisplayedtothelowersidesoftheHSIanddisplaythefollowing
information:
•Bearingsource(NAV,GPS,ADF)
• Pointericon(BRG1=singleline,BRG2=doubleline)
•Frequency(NAV,ADF)
•Station/waypointidentier(NAV,GPS)
•GPS-derived great circle distance to bearing
source
WhentheNAVradioistunedtoanILSfrequencythebearingsourceandthebearingpointerisremoved
fromtheHSI.WhenNAV1orNAV2istheselectedbearingsource,thefrequencyisreplacedbythestation
identierwhenthestationiswithinrange.IfGPSisthebearingsource,theactivewaypointidentieris
displayedinlieuofafrequency.
ThebearingpointerisremovedfromtheHSIand“NODATA”isdisplayedintheinformationwindowif
theNAVradioisnotreceivingthetunedVORstationorifGPSisthebearingsourceandanactivewaypoint
is not selected.
Selecting bearing display and changing sources:
1) Select the PFD Softkey.
2) Select a BRG Softkey to display the desired bearing pointer and information window with a NAV source.
3) Select the BRG Softkey again to change the bearing source to GPS.
4) To remove the bearing pointer and information window, select the BRG Softkey again.
DME INFORMATION WINDOW
The DMEInformationWindowisdisplayedabovetheBRG1InformationWindowonthe360˚HSIandin
aboxaboveandalongsidetheArcHSI.ItshowstheDMElabel,tuningmode(NAV1,NAV2,orHOLD),
frequency,anddistance.Whenasignalisinvalid,thedistanceisreplacedby–.––NMRefertotheAudio
PanelandCNSSectionforinformationontuningtheDME.
NOTE: DME installation is optional.
Displaying the DME Information Window:
1) Select the PFD Softkey.
2) Select the DME Softkey to display the DME Information Window.
3) To remove the DME Information Window, select the DME Softkey again.