Pilot's Guide

Garmin G1000 Pilot’s Guide for the Cessna Corvalis/Corvalis TT
190-00552-05 Rev. A
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
512
APPENDIX A
Message Comments
DB MISMATCH – Obstacle database
mismatch.
The PFD and MFD have different obstacle database versions or regions installed.
Check the AUX-SYSTEM STATUS Page to determine versions or regions. Also,
check the AUX-SYSTEM STATUS Page for a database synchronization function not
completed. After synchronization is complete, power must be turned off, then on.
DB MISMATCH – Airport Terrain
database mismatch.
The PFD and MFD have different airport terrain database versions or regions installed.
Check the AUX-SYSTEM STATUS Page to determine versions or regions. Also,
check the AUX-SYSTEM STATUS Page for a database synchronization function not
completed. After synchronization is complete, power must be turned off, then on.
NAV DB UPDATED – Active
navigation database updated.
System has updated the active navigation database from the standby navigation
database.
TERRAIN DSP – [PFD1 or MFD1]
Terrain awareness display unavailable.
One of the terrain, airport terrain, or obstacle databases required for TAWS in the PFD
or MFD is missing or invalid.
GIA 63 INTEGRATED AVIONICS UNIT MESSAGE ADVISORIES
Message Comments
GIA1 CONFIG – GIA1 config error.
Config service req’d.
The GIA1 and/or GIA2 configuration settings do not match backup configuration
memory. The G1000 system should be serviced.
GIA2 CONFIG – GIA2 config error.
Config service req’d.
GIA1 CONFIG – GIA1 audio config
error. Config service req’d.
The GIA1 and/or GIA2 have an error in the audio configuration. The G1000 system
should be serviced.
GIA2 CONFIG – GIA2 audio config
error. Config service req’d.
GIA1 COOLING – GIA1 temperature
too low.
The GIA1 and/or GIA2 temperature is too low to operate correctly. Allow units to
warm up to operating temperature.
GIA2 COOLING – GIA2 temperature
too low.
GIA1 COOLING – GIA1 over
temperature.
The GIA1 and/or GIA2 temperature is too high. If problem persists, the G1000 system
should be serviced.
GIA2 COOLING – GIA2 over
temperature.
GIA1 SERVICE – GIA1 needs service.
Return the unit for repair.
The GIA1 and/or GIA2 self-test has detected a problem in the unit. The G1000 system
should be serviced.
GIA2 SERVICE – GIA2 needs service.
Return the unit for repair.
MANIFEST – GFC software mismatch,
communication halted.
Incorrect servo software is installed, or gain settings are incorrect.
MANIFEST – GIA1 software
mismatch, communication halted.
The GIA1 and/or GIA 2 has incorrect software installed. The G1000 system should be
serviced.
MANIFEST – GIA2 software
mismatch, communication halted.