Pilot's Guide

190-00552-05 Rev. A
Garmin G1000 Pilot’s Guide for the Cessna Corvalis/Corvalis TT
127
AUDIO PANEL AND CNS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
VFR CODE
Press the XPDR Softkey, then the VFR Softkey to display the pre-programmedVFRcodeinthecodeeldof
theTransponderDataBox.Pressthe VFR Softkey again to restore the previous identification code.
Thepre-programmedVFRCodeissetatthefactoryto1200.IfaVFRcodechangeisrequired,contacta
Garmin-authorized service center for configuration.
Figure 4-47 VFR Code
VFR Code
IDENT FUNCTION
NOTE: In Standby Mode, the IDENT Softkey is inoperative.
Select the IDENT Softkey to send a distinct identity indication to Air Traffic Control (ATC). The indication
distinguishes the identing transponder from all the others on the air traffic controller’s screen. The IDENT
Softkey appears on all levels of transponder softkeys. When the IDENT Softkey is selected, a green IDNT
indicationisdisplayedinthemodeeldoftheTransponderDataBoxforadurationof18seconds.
After the IDENT Softkey is selected while in Mode or Code Selection, the system reverts to the top-level
softkeys.
Select the
IDENT Softkey
to Initiate the
ID Function
IDNT
Indication
Figure 4-48 IDENT Softkey and Indication