Pilot's Guide

190-00595-00 Rev. A
Garmin G1000 Pilot’s Guide for Beechcraft A36/G36
3-7
EIS
1
Engine Manifold Pressure
Gauge (MAN IN)
Displays engine power in inches of Mercury (in Hg)
2
Tachometer
(RPM)
Shows propeller speed in revolutions per minute (rpm); the red area
indicates propeller overspeed
3
Oil Temperature
(OIL °C)
Oil temperature is shown in degrees Celsius (°C)
4
Oil Pressure
(OIL PSI)
Oil pressure is displayed in pounds per square inch (psi)
5
Fuel Flow
(FFLOW GPH)
Displays fuel flow in gallons per hour (gph)
6
Calculated Fuel Remaining
(GAL REM)
Shows the totalizer-based fuel remaining in gallons, adjusted by the
pilot using the FUEL softkeys
7
Calculated Fuel Used
(GAL USED)
Shows the fuel used in gallons, based on fuel flow
8
Calculated Endurance
(ENDUR)
Shows the calculated endurance in hours:minutes (HH:MM)
9
Calculated Range
(RANGE NM)
Shows the calculated range in nautical miles (nm)
10
Ammeter
(ALT LOAD)
Displays loads for alternators 1 and 2 in amperes
11
Voltmeter
(BUS VOLTS)
Displays the primary bus voltages for buses 1 and 2
Fuel calculations are based on the fuel flow totalizer and the displayed fuel remaining (GAL REM), adjusted by
the pilot using the following softkeys:
• DEC FUEL – Decreases totalizer-based fuel remaining in one-gallon increments
• INC FUEL – Increases totalizer-based fuel remaining in one-gallon increments
• RST FUEL – Resets totalizer-based fuel remaining to the aircraft’s fuel capacity
Accessing the EIS System Display:
1) Press the ENGINE Softkey.
2) Press the SYSTEM Softkey.
3) To return to the default Engine Display, press the ENGINE or BACK Softkey.
Adjusting the fuel totalizer quantity:
From the System Display, press the DEC FUEL or INC FUEL Softkey to obtain the desired number of gallons
remaining (GAL REM).
Resetting the fuel totalizer:
From the System Display, press the RST FUEL Softkey. This also resets the displayed fuel remaining (GAL REM)
to zero.