Pilot's Guide

ManualsBrandsGarmin ManualsFlight DecksGarmin Software Version 0464.00

Garmin G1000 Pilot’s Guide for the Tiger AG-5B 190-00617-00 Rev. A

2-36

SUPPLEMENTAL FLIGHT DATA

Load Arrival

Load Arrival allows the pilot to select a published stan-

dard terminal arrival route (STAR) for the destination air

port, or replace a current arrival with a new selection.

NOTE

The PROC key can also be used to load a

departure, an approach, or an arrival.

To select an arrival for a direct-to or ﬂight

plan destination airport:

1. From the Flight Plan window, press the

key to display the page menu options.

2. Turn the

FMS

knob to highlight ‘Load Arrival’,

then press the

ENT

key. A window appears

listing the available arrivals for the destination

airport.

3. Turn the

FMS

knob to select the desired arrival,

then press the

ENT

key. A window appears

listing the available transitions for the arrival.

4. Turn the

FMS

knob to select the desired transi-

tion waypoint, then press the

ENT

key.

NOTE: This runway window is not displayed for

every arrival. ‘ALL’ may appear in the runway

ﬁeld, indicating that the arrival procedure applies

to all runways. For airports with parallel runways,

‘B’ may appear at the end of the runway designa-

tion to indicate that the arrival procedure applies

to both runways.

5. A window may appear listing runways for the

arrival. Turn the

FMS

knob to select the desired

runway, then press the

ENT

key. With ‘LOAD?’

highlighted, press the

ENT

key.

When adding an arrival to an active ﬂight plan, the pi-

lot may need to remove a duplicate destination waypoint

from the ﬂight plan list.

Load Approach

Load Approach allows the pilot to select a published

instrument approach for the destination airport, or re

place the current approach with a new selection.

To select an approach for a direct-to or

ﬂight plan destination airport:

1. From the Flight Plan window, press the

key to display the page menu options.

2. Turn the

FMS

knob to highlight ‘Load Approach’,

then press the

ENT

key. A window appears list-

ing the available approaches for the destina

tion airport.

3. Turn the

FMS

knob to select the desired

approach, then press the

ENT

key. A window

appears listing the available transitions for the

approach.

NOTE: The ‘Vectors’ option assumes that the pilot

will receive vectors from ATC to the ﬁnal course

segment of the approach.

4. Turn the

FMS

knob to select the desired transi-

tion or vectors, then press the

ENT

key. With

‘LOAD?’ highlighted, press the

ENT

key to load

the approach.

5. To activate the approach, turn the

large FMS

knob to highlight ‘ACTIVATE?’, then press the

ENT

key.

‘LOAD’ adds the approach to the ﬂight plan without

immediately using the approach for navigation guidance.

This allows the pilot to continue navigating the original

ﬂight plan until cleared for the approach, but keeps the

approach available for quick activation when needed.

‘ACTIVATE’ adds the approach to the ﬂight plan and be-

gins navigating the approach course.

PFD.indd 36 7/11/2005 4:28:54 PM