Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Tiger AG-5B
10-2
SECTION 10 – HAZARD
AVOIDANCE
At a map range of less than 25 nm, Stormscope light-
ning data is not displayed, but can still be present. The
presence of Stormscope lightning data is indicated by the
annunciation ‘LTNG < 25 nm’ in the upper right corner.
Figure 10-5 Lightning Display Range Annunciation
To select ‘cell’ or ‘strike’ as the Stormscope
lightning mode:
1. With the Weather Group selected, press the
ENT key. The cursor flashes on ‘STRMSCP
LTNG’.
2. Turn the
large FMS knob to select ‘STRMSCP
MODE’.
3. Turn either
FMS knob to display the ‘Cell/Strike’
window.
4. Turn either
FMS knob to select ‘Cell’ or ‘Strike’.
Press the ENT key.
5. Push the
FMS knob to return to the Navigation
Map Page.
To clear Stormscope lightning data from
the Navigation Map Page:
1. Press the
MENU key (with the Navigation Map
Page displayed).
2. Turn either
FMS knob to highlight the ‘Clear
Lightning Data’ field and press the ENT key.
Stormscope Page
1. Turn the large FMS knob until the Map Page
group is selected.
2. Turn the small FMS knob until the Stormscope
Page is selected. This is the third rectangular
page icon.
Figure 10-6 Stormscope Page
To change the Stormscope lightning mode
between ‘cell’ and ‘strike’:
1. Select the Stormscope Page.
2. Press the
MODE softkey. The CELL and STRIKE
softkeys are displayed. Press the CELL softkey
to display ‘CELL’ data or press the
STRIKE soft-
key to display ‘STRIKE’ data. ‘CELL’ or ‘STRIKE’
is displayed in the mode box located in the
upper left corner of the Stormscope Page.
NOTE: “Cell mode” uses a clustering program to
identify clusters of electrical activity that indicate
cells.
To change the viewing mode between 360 ˚
and 120˚:
1. Select the Stormscope Page.