Pilot's Guide

190-00494-04 Rev. A
Garmin G1000 Pilot’s Guide for the Cessna Citation Mustang
137
AUDIO PANEL AND CNS
VFR CODE
The VFRcodecanbeenteredeithermanuallyorbypressingthe XPDR Softkey, then the VFR Softkey.
When the VFR Softkeyispressed,thepre-programmedVFRcodeisautomaticallydisplayedinthecodeeld
oftheTransponderDataBox.Pressingthe VFR Softkeyagainrestoresthepreviousidenticationcode.
Thepre-programmedVFRCodeissetatthefactoryto1200.IfaVFRcodechangeisrequired,contacta
Garmin-authorizedservicecenterforconguration.
Figure 4-48 VFR Code
VFR Code
IDENT FUNCTION
NOTE: In Standby Mode, the IDENT Softkey is inoperative.
Pressing the IDENT SoftkeysendsadistinctidentityindicationtoAirTrafcControl(ATC).Theindication
distinguishestheidentingtransponderfromalltheothersontheairtrafccontroller’sscreen.The IDENT
Softkey appears on all levels of transponder softkeys. When the IDENT Softkey is pressed, a green IDNT
indicationisdisplayedinthemodeeldoftheTransponderDataBoxforadurationof18seconds.
After the IDENT Softkey is pressed while in Mode or Code Selection, the system reverts to the top-level
softkeys.
Press the
IDENT Softkey
to Initiate the
ID Function
IDNT
Indication
Figure 4-49 IDENT Softkey and Indication