Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang
190-00600-03 Rev. A
Appendix
105
Flight
Instruments EICAS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
Canceling an automatic database synchronization:
1) While synchronization is in progress, select the SYNC DBS Softkey to
disable (Figure B-2) automatic database synchronization.
2) Acknowledge the cancelation by pressing the ENT Key.
Loading the Jeppesen navigation database:
NOTE: Loading the Jeppesen navigation database prior to its effective date
will result in the expiration date on the power-up screen and the effective
date on the AUX-System Status Page being displayed in yellow.
1) Copy the new navigation database to an SD card obtained from Garmin, or
the aircraft manufacturer.
2) With the G1000 system OFF, insert the SD card containing the new
navigation database version into the top card slot of the MFD (label of SD
card facing left).
3) Turn the G1000 system ON. A prompt similar to the following illustration is
displayed:
Navigation Database Load Prompt
4) Select the YES Softkey to update the navigation database in the MFD.
5) After the update completes, the display starts in normal mode.
6) Turn the G1000 system OFF and remove the SD card from the top card slot.
7) Repeat steps 2 through 6 for PFD1.
8) Repeat steps 2 through 6 for PFD2.
9) Apply power to the system and press the ENT Key to acknowledge the
startup screen.
10) Turn the large FMS Knob to select the AUX Page group on the MFD.