Pilot's Guide

3-15190-01150-02 Rev. F
Garmin G500H Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
Auto Zoom
With a valid flight plan, the Auto Zoom feature will automatically change the
Navigation Map range depending on the distance to the next waypoint in the flight
plan. If enabled, it will also automatically zoom to 1 NM when the aircraft is on
the ground or when GPS altitude is less than 400 ft AGL and groundspeed is less
than 40 knots. Auto Zoom can be overridden at any time by manually zooming
with the RNG keys or enabling OBS mode. Auto Zoom is re-enabled once one of
the following conditions is met:
1) A waypoint is sequenced,
2) the aircraft transitions from “on ground” to “in air,”
3) a point is reached where the Auto Zoom range matches the manual override
range (known as auto-sync),
4) Auto Zoom is toggled off and back on in the Navigation Map Setup page,
OR
5) OBS mode is turned off.
Figure 3-19 Navigation Map Auto Zoom