Pilot's Guide

Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi
190-00663-02 Rev. B70
FLIGHT INSTRUMENTS
IfthesameVOR/LOCnavigationsourceisselectedonbothPFDs,thenavigationsourceannunciationturns
yellowonbothdisplays(unlesssynchronized).OncetheCDIsaresynchronized(CDISYNCturnedon),they
remain synchronized until the setting is turned off.
Synchronizing the CDIs:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the ‘CDI Sync’ in the Synchronization box.
4) Turn the small FMS Knob clockwise to ON or counterclockwise to OFF.
Figure 2-28 System Setup Page, CDI Synchronization
ThesystemautomaticallyswitchesfromGPStoLOCnavigationsourceandchangestheCDIscalingaccordingly
when all of the following occur:
•AlocalizerorILSapproachhasbeenloadedintotheactiveightplan
•Thenalapproachx(FAF)istheactivel,theFAFislessthan15nmaway,andtheaircraftismovingtoward
theFAF
•Avalidlocalizerfrequencyhasbeentuned
•TheGPSCDIdeviationislessthan1.2timesfull-scaledeection