Pilot's Guide

190-00663-02 Rev. B

Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi

FLIGHT INSTRUMENTS

When a bearing pointer is displayed, its associated information window is also displayed. The Bearing

Informationwindows(Figure2-24)aredisplayedtothelowersidesoftheHSIandshow:

•Bearingsource(NAV,GPS,ADF)

• Pointericon(BRG1=singleline,BRG2=doubleline)

•Frequency(NAV)

•Station/waypointidentier(NAV,GPS)

•GPS-derived great circle distance to bearing

source

IftheNAVradioisthebearingsourceandistunedtoanILSfrequency(refertotheAudioPanelandCNS

Sectionforinformationontuningtheradios),thebearingpointerisremovedfromtheHSIandthefrequency

isreplacedwith“ILS”.WhenNAV1orNAV2istheselectedbearingsource,thefrequencyisreplacedbythe

station identiﬁer when the station is within range. If GPS is the bearing source, the active waypoint identiﬁer

isdisplayedinlieuofafrequency.

ThebearingpointerisremovedfromtheHSIand“NODATA”isdisplayedintheinformationwindowif:

•TheNAVradioisnotreceivingthetunedVOR

station

•GPSisthebearingsourceandanactivewaypoint

is not selected

Selecting bearing display and changing sources:

1) Press the PFD Softkey.

2) Press a BRG Softkey to display the desired bearing pointer and information window with a NAV source.

3) Press the BRG Softkey again to change the bearing source to GPS.

4) Press the BRG Softkey a third time to change the bearing source to ADF (note: ADF radio installation is

optional).

5) To remove the bearing pointer and information window, press the BRG Softkey again.

DME INFORMATION WINDOW

NOTE: DME radio installation is optional.

The DMEInformationWindow(Figure2-24)isdisplayedabovetheBRG1InformationWindowandshows

theDMElabel,tuningmode(NAV1,NAV2,orHOLD),frequency,anddistance.Whenasignalisinvalid,

thedistanceisreplacedby“–.––NM”.RefertotheAudioPanelandCNSSectionforinformationontuning

the radios.

Displaying the DME Information Window:

1) Press the PFD Softkey.

2) Press the DME Softkey to display the DME Information Window above the BRG1 Information Window.

3) To remove the DME Information Window, press the DME Softkey again.