Pilot's Guide

190-00663-02 Rev. B
Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi
557
APPENDIX B
15) Turn system power ON.
16) Press the ENT Key to acknowledge the startup screen.
17) Turn the large FMS Knob to select the AUX Page group on the MFD.
18) Turn the small FMS Knob to select the System Status Page.
19) Press the Display Database Selection Softkey to show standby navigation database information for each display
(MFD1 DB, PFD1 DB, PFD2 DB). Verify the correct standby navigation database cycle information is shown
for each display.
NOTE: The system compares the active databases on each PFD and the MFD, and displays a system alert
message ‘DB Mismatch’ if they are not identical. Similarly, if the standby databases on each PFD and the
MFD are not identical, the system will display a ‘DB Mismatch’ alert for the standby navigation databases.
GARMIN DATABASES
The following databases are stored on Supplemental Data Cards provided by Garmin:
•Expandedbasemap
•Terrain
•Airportterrain
•Obstacle
•SafeTaxi
•FliteCharts
•AirportDirectory
After subscribing to the desired database product, these database products will be downloaded to three
Supplemental Data Cards (with the exception of FliteCharts, which is loaded on only one card). Insert each
Supplemental Data Card into the correct location shown in Figure B-5. These cards must not be removed
except to update the databases stored on each card.
Figure B-7 Correct Database Locations
MFD
PFD1
PFD2
Since these databases are not stored internally in the displays, a Supplemental Data Card containing identical
database versions must be kept in each display unit.
The basemap database contains data for the topography and land features, such as rivers, lakes, and towns.
It is updated only periodically, with no set schedule. There is no expiration date.