Pilot's Guide

Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi
190-00663-02 Rev. B546
APPENDIX A
MISCELLANEOUS MESSAGE ADVISORIES
Message Comments
FPL WPT LOCK – Flight plan waypoint
is locked.
Upon power-up, the G1000 system detects that a stored flight plan waypoint is
locked. This occurs when an navigation database update eliminates an obsolete
waypoint. The flight plan cannot find the specified waypoint and flags this message.
This can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
Or - update the waypoint name/identifier to reflect the new information.
FPL WPT MOVE – Flight plan
waypoint moved.
The system has detected that a waypoint coordinate has changed due to a new
navigation database update. Verify that stored flight plans contain correct waypoint
locations.
TIMER EXPIRD – Timer has expired. The system notifies the pilot that the timer has expired.
DB CHANGE – Database changed.
Verify user modified procedures.
This occurs when a stored flight plan contains a procedure that is no longer consistent
with the navigation database. This alert is issued only after an navigation database
update. Verify that the user-modified procedures in stored flight plans are correct and
up to date.
DB CHANGE – Database changed.
Verify stored airways.
This occurs when a stored flight plan contains an airway that is no longer consistent
with the navigation database. This alert is issued only after an navigation database
update. Verify use of airways in stored flight plans and reload airways as needed.
ESP CONFIG – ESP config error.
Config service req’d.
The ESP function is not installed correctly. ESP is not available. The system should be
serviced.
FPL TRUNC – Flight plan has been
truncated.
This occurs when a newly installed navigation database eliminates an obsolete
approach or arrival used by a stored flight plan. The obsolete procedure is removed
from the flight plan. Update flight plan with current arrival or approach.
LOCKED FPL – Cannot navigate
locked flight plan.
This occurs when the pilot attempts to activate a stored flight plan that contains
locked waypoint. Remove locked waypoint from flight plan. Update flight plan with
current waypoint.
WPT ARRIVAL – Arriving at waypoint
-[xxxx]
Arriving at waypoint [xxxx], where [xxxx] is the waypoint name.
STEEP TURN – Steep turn ahead. A steep turn is 15 seconds ahead. Prepare to turn.
INSIDE ARSPC – Inside airspace. The aircraft is inside the special use airspace.
ARSPC AHEAD – Airspace ahead less
than 10 minutes.
Special use airspace is ahead of aircraft. The aircraft will penetrate the special use
airspace within 10 minutes.
ARSPC NEAR – Airspace near and
ahead.
Special use airspace is near and ahead of the aircraft position.
ARSPC NEAR – Airspace near – less
than 2 nm.
Special use airspace is within 2 nm of the aircraft position.
APPR INACTV – Approach is not
active.
The system notifies the pilot that the loaded approach is not active. Activate
approach when required.
SLCT FREQ – Select appropriate
frequency for approach.
The system notifies the pilot to load the approach frequency for the appropriate NAV
receiver. Select the correct frequency for the approach.
SLCT NAV – Select NAV on CDI for
approach.
The system notifies the pilot to set the CDI to the correct NAV receiver. Set the CDI to
the correct NAV receiver.
PTK FAIL – Parallel track unavailable:
bad geometry.
Bad parallel track geometry.