Pilot's Guide

190-00663-02 Rev. B
Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi
381
HAZARD AVOIDANCE
OPERATION
Theunitmustbeinoperatingmodefortrafctobedisplayed.Theabilitytoswitchfromstandbytooperating
modeonthegroundisespeciallyusefulforscanningtheairspacearoundtheairportbeforetakeoff.
Switching from standby mode to operating mode:
1) On the Traffic Map Page, select the OPERATE Softkey or press the MENU Key and turn the small FMS knob to
select Operating Mode.
2) If using the FMS menu, press the ENT Key to place the traffic system in the operating mode.
3) To switch to Standby Mode from the Traffic Map Page, select the STANDBY Softkey.
System Test:
1) Set the range to 2/6 nm to allow for full test pattern display.
2) Select the STANDBY Softkey.
3) Select the TEST Softkey. ‘TEST MODE’ is annunciated on the MFD.
4) System test takes approximately eight seconds to complete. If successful, traffic symbols appear and a voice
alert indicates the system test passed.
DISPLAYING TRAFFIC DATA
Trafcinformationcanbedisplayedonthefollowingmapswhentheunitisoperating:
•PFDInsetMap
•NavigationMapPage
•TrafcMapPage
•TripPlanningPage
•ActiveFlightPlanPage
•NearestPages
TrafcinformationcanalsobedisplayedonthePFDwhentheSyntheticVisionSystem(SVS)optionis
installedandenabled.SeetheAdditionalFeaturesSectionfordetails.
Displaying traffic on the Traffic Map Page:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Select the OPERATE Softkey to begin displaying traffic. OPERATING is displayed in the Traffic mode field.
4) Select the ALT MODE Softkey to change the altitude volume.
5) Select the STANDBY Softkey to place the system in the Standby mode. STANDBY is displayed in the Traffic
mode field.
6) Turn the RANGE Knob clockwise to display a larger area or counter-clockwise to display a smaller area.