Pilot's Guide

190-00663-02 Rev. B
Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi
27
SYSTEM OVERVIEW
If the sensor annunciation persists, check for a system failure message in the Messages Window on the PFD.
If no failure message exists, check the GPS Status Page and compare the information for GPS1 and GPS2.
Discrepancies may indicate a problem.
Viewing GPS receiver status information
1) Use the large FMS Knob to select the Auxiliary Page Group (see Section 1.7 for information on navigating MFD
page groups).
2) Use the small FMS Knob to select GPS Status Page.
Selecting the GPS receiver for which data may be reviewed
1) Use the FMS Knob to select the AUX - GPS Status Page.
2) To change the selected GPS receiver:
a) Select the desired GPS Softkey.
Or:
a) Press the MENU Key.
b) Use the FMS Knob to highlight the receiver which is not selected and press the ENT Key.
Figure 1-22 GPS Status Page (RAIM or SBAS Selected)
Satellite Signal
Strength Bars
Satellite Constellation
Diagram
Satellite Signal
Information Status
RAIM
Availability
Prediction
GPS Receiver
Status
EGNOS,
MSAS and
WAAS
Selected
RAIM Softkey
Selected
SBAS Softkey
Selected
GPS Selection
Softkeys