Pilot's Guide

Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi
190-00663-02 Rev. B374
HAZARD AVOIDANCE
Figure 6-102 Navigation Map Page Setup Menu
Figure 6-101 Navigation Map Page Menu
Figure 6-103 Navigation Map Page Setup Menu, Traffic Group
TRAFFIC MAP PAGE
TheTrafcMapPageisspecializedtoshowsurroundingTIStrafcdatainrelationtotheaircraft’scurrent
positionandaltitude,withoutclutterfromthebasemap(Figure6-104).Aircraftorientationonthismapis
alwaysheadingupunlessthereisnovalidheading.MaprangeisadjustablewiththeRANGE Knobfrom2to
12nm,asindicatedbythemaprangerings.
ThetrafcmodeisannunciatedintheupperleftcorneroftheTrafcMapPage.Whentheaircraftisonthe
ground,TISautomaticallyentersStandbyMode.Oncetheaircraftisairborne,TISswitchesfromStandbyto
OperatingModeandthesystembeginstodisplaytrafcinformation.RefertotheSystemStatusdiscussionfor
more information.
Displaying traffic on the Traffic Map Page:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Confirm TIS is in Operating Mode:
Select the OPERATE Softkey to begin displaying traffic.
Or:
a) Press the MENU Key.
b) Select ‘Operate Mode’ (shown if TIS is in Standby Mode) and press the ENT Key.