Pilot's Guide

190-00663-02 Rev. B Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi 22
SYSTEM OVERVIEW
PFD Displays second-level softkeys for additional PFD configurations
SYN VIS Displays the softkeys for enabling or disabling Synthetic Vision features
PATHWAY Displays rectangular boxes representing the horizontal and vertical flight path of the
active flight plan
SYN TERR Enables synthetic terrain depiction
HRZN HDG Displays compass heading along the Zero-Pitch line
APTSIGNS Displays position markers for airports within approximately 15 nm of the current aircraft
position. Airport identifiers are displayed when the airport is within approximately 9
nm.
DFLTS Resets PFD to default settings, including changing units to standard
WIND Displays softkeys to select wind data parameters
OPTN 1 Total direction and speed
OPTN 2 Total direction with digital direction and magnitude
OPTN 3 Longitudinal and lateral components
OFF Information not displayed
DME Displays DME Informatin Window (optional)
BRG1 Cycles the Bearing 1 Information Window through NAV1 or GPS waypoint identifier and
GPS-derived distance information, and ADF/frequency.
HSI FRMT Displays the softkeys for selecting the two HSI formats
360 HSI Displays HSI as a 360° compass rose
ARC HSI Displays HSI as a 140° viewable arc
BRG2 Cycles the Bearing 2 Information Window through NAV2 or GPS waypoint identifier and
GPS-derived distance information, and ADF/frequency.
ALT UNIT Displays softkeys for setting the altimeter and BARO settings to metric units
METERS When enabled, displays altimeter in meters
IN Press to display the BARO setting as inches of mercury
HPA Press to display the BARO setting as hectopacals
STD BARO Sets barometric pressure to 29.92 in Hg (1013 hPa if metric units are selected)
OBS Selects OBS mode on the CDI when navigating by GPS (only available with active leg)
CDI Cycles through GPS, VOR1, and VOR2 navigation modes on the CDI
DME Displays the DME Tuning Window, allowing tuning and selection of the DME (optional)
XPDR Displays transponder mode selection softkeys
XPDR1 Selects the #1 transponder as active
XPDR2 Selects the #2 transponder as active
STBY Selects standby mode (transponder does not reply to any interrogations)
ON Selects Mode A (transponder replies to interrogations)
ALT Selects Mode C – altitude reporting mode (transponder replies to identification and
altitude interrogations)