Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Hawker Beechcraft C90A/GT/GTi 190-00664-02 Rev. B
Appendix
98
Flight
Instruments
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
FeaturesAnnun/AlertsAppendixIndex
Loading the Standby Navigation Database
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1) With the system OFF, insert the SD card containing the new navigation
database version into the top card slot of the MFD.
2) Verify that an SD card is inserted in the bottom slot of each PFD and the
MFD.
3) Turn the system ON. A prompt is displayed.
4) Press the YES Softkey. The navigation database is copied to the SD card in
the bottom card slot of the MFD.
5) After the navigation database files are copied to the bottom SD card, press
any key to continue, as instructed.
7) Again, press any key to continue as instructed on the display.
8) Press the NO Softkey. The display now starts in normal mode. Since the
database effective date is not yet valid, it should not be loaded as the
active database. The display now starts in normal mode. Do not remove
power while the display is starting.
9) Press the ENT Key to acknowledge the startup screen.
10) Turn the large FMS Knob to select the AUX Page group on the MFD.
11) Turn the small FMS Knob to select the System Status Page.
12) The new database is copied to the SD card in the bottom card slot of each
PFD. Progress can be monitored in the SYNC STATUS field. When copying
is finished, ‘Complete’ is displayed.
13) Turn system power OFF.