Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air Page 3-37
190-00716-01 Revision 4
3.23 TAWS-A Support Configuration
This section applies only to installations with the TAWS-A option. The procedures outlined in this
section must be followed to load the necessary configuration files required to enable TAWS-A gear and
flap messages. A TAWS-A enable card is also required for this option (see Section 3.38).
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the
“SYSTEM UPLOAD” page using the small FMS knob on PFD1.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS to highlight “King Air – Airframe Options” and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “King Air - TAWS-A Support”. Press ENT key on
PFD1.
4. Verify the “King Air -TAWS-A Support” is displayed in the “Item” window. Press “LOAD”
softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in the Configuration column for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.