Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air Page 3-31
190-00716-01 Revision 4
3.17 GSR 56 Satellite Reciever Stand-Alone Option Configuration
Follow this procedure to enable the optional GSR 56 satellite receiver function when installed as a stand-
alone option. Stand-alone GSR 56 configurations do not require the GDL 59 Wi-Fi data link software
configuration/installation. Coordinate the GSR 56 stand-alone configuration with Section 7.30 “GSR 56
Satellite Receiver Functional Check”.
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the
“SYSTEM UPLOAD” page using the small FMS knob on PFD1.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS knob to highlight “King Air – Garmin Options” and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “King Air - GSR 56 Stand Alone”. Press ENT key on
PFD1.
4. Verify “King Air - GSR 56 Stand Alone” is displayed in the “Item” window. Press “LOAD”
softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in the Configuration column for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.