Instruction Manual

Page 3-26 G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Revision 4 190-00716-01
3.12 GTS Processor
Follow this procedure to enable the GTS Processor traffic system function for the G1000 system if
required.
NOTE
Configuration of the GTS Processor will require the GTS system to be
configured with the aircraft mode S address. Coordinate this configuration
with Section 3.45 “Aircraft Registration Number Entry”. The default
configuration for the GTS system is TAS. See Section 3.43 for TCAS I enable
and Section 3.44 for TCAS II enable. Coordinate the GTS Processor (TAS)
configuration with Section 7.27 “GTS Traffic System Functional Check”.
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the “System
Upload” page on PFD1 using the small FMS knob.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS knob to highlight “King Air – Garmin Options” and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “King Air - GTS Processor”. Press ENT key on PFD1.
4. Verify the “King Air - GTS Processor” is displayed in the “Item” window. Press “LOAD”
softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in the Configuration and Software columns for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.