Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air Page 3-23
190-00716-01 Revision 4
3.9.3 Software Load Confirmation
Anytime software and configuration loading procedures are accomplished during maintenance, conduct a
final software review of the system.
1. Start the G1000 system in Configuration Mode as described in Section 3.7.
2. Press the small FMS knob to activate the cursor on the System Status page of the PFD or MFD.
3. Highlight each of the items in the LRU window by activating the cursor (pushing the FMS knob as
required) to verify the software part number and version displayed matches with the information in
the General Arrangement drawing listed in Table 1-2.
IMPORTANT!
It is essential that the software versions be checked and matched against the listed
versions in the General Arrangement drawing listed in Table 1-2. Software
Configuration is a critical part of the G1000 operation and must be verified before
returning an aircraft to service.
If any software version and/or part number does not match those specified by the General
Arrangement drawing, or if the software is not successfully loaded, DO NOT continue.
Troubleshoot and resolve the issue before continuing.