Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air Page 3-21
190-00716-01 Revision 4
3.9.2 G1000 System Software Upload
The System Upload page allows a technician to load LRU software and system configuration files
individually or in an automated sequence. Depending on what maintenance is performed, software and/or
configuration files may need to be reloaded to LRUs. Follow the steps below as a guide to use the
System Upload page.
IMPORTANT!
Do not allow power to be removed from the system when loading software. Remove
power only when instructed by the following procedure. As a general rule, all
displays should be in the same mode (configuration or normal) unless instructed
otherwise.
1. Ensure loader card is inserted into top card slot of PFD1 and PFD1 is in configuration mode. On
PFD1, select the “System Upload” page using the PFD1 small FMS knob.
2. Activate the cursor and use the PFD1 small FMS knob to highlight the GROUP field. Scroll small
FMS knob to select the appropriate airframe (King Air 300 Series PT6A-60A or King Air B300
Series PT6A-60A). Press the PFD1 ENT key to select the configuration.
Figure 3-17, Airframe Options
3. Once an airframe type is selected the cursor moves to the ITEM window. Rotate the PFD1 small
FMS knob to activate the drop-down menu. Move the cursor to highlight the appropriate propeller
configuration for the aircraft and press ENT on PFD1.
Figure 3-18, Propeller Options
4. Once the propeller type is selected the cursor moves to the PRODUCT window. Select the software
and/or configuration which is to be loaded for each G1000 LRU.