Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air Page 4-3
190-00716-01 Revision 4
4.2.2 Required Tools
The following tools are needed to perform maintenance tasks on G1000 equipment:
• Calibrated Milli-ohm meter, OR
• Agilent 34410A Ammeter or equivalent
• Fluke 187 Voltmeter or equivalent
• Variable DC Power Supply capable of providing 1 amp current
• #2 Non-Magnetic Phillips Screwdriver
• 3/32” Hex tool
• Calibrated digital level (Required for AHRS ‘Procedure A’ Calibration)
• Calibrated VHF NAV/COM/ILS ramp tester or equivalent
• Calibrated transponder ramp tester or equivalent
• Calibrated pitot/static ramp tester
• Outdoor line-of-site to GPS satellite signals or GPS indoor repeater
• Headset/microphone
• Ground Power Unit (Capable of supplying 28 Vdc)
• Calibrated Flight Control Cable Tension Meter or equivalent
• 2 Amp, 24 V, DC Power Supply
• Calibrated torque wrench capable of measuring 0 – 70 in/lbs
• Standard sockets & wrenches (3/8”, 9/16”, and 13/16”)
• Calibrated digital thermometer suitable for measuring ambient temperature
• Laptop with RS232 emulation software
• M22885/108T8234 extraction tool
• An 0.060” 6-Spline wrench
4.2.3 Special Tools
The following tools are needed to perform maintenance tasks on G1000 equipment and/or installation:
• Servo Gearbox Slip Clutch Adjustment Tool – Garmin P/N T10-00110-01
• WX-PA portable analyzer kit, Part Number 78-8060-5791-1 (If Stormscope is installed)
• Gauging Equipment Tool SPF-4 (A1M-BCH-GE) *
• For software loader code 0985.07 – GRA 5500 Sensor and Main Software (If GRA 5500 is
installed) – Garmin P/N per GA Drawing 005-00421-03 obtained from www.garmin.com web-
site from instructions in Section 3.28.1
• For software loader code 0985.07 – GRA 5500 Retrofit Tool (If GRA 5500 is installed) – Garmin
P/N 006-A0451-00 obtained from www.garmin.com web-site from instructions in Section 3.28.2
* The gauging equipment tool is used for the static port inspection for RVSM
compliant aircraft only. This tool is available from Hawker Beechcraft. Any
alternate tool authorized in the Super King Air 300 or B300 Maintenance Manual for
RVSM static port measurements may be substituted for this tool. Refer to Chapter
34-10-00 of the Super King Air 300 or B300 Maintenance Manual for more details.