Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air Page 3-59
190-00716-01 Revision 4
3.42 Optional Search and Rescue Enable
Follow this procedure to enable the Search and Rescue (SAR) function. A SAR Enable Card, as specified
on the General Arrangement Drawing 005-00629-02, will be required for this procedure.
NOTE
The G1000 has various features that require the use of unlock/enable cards to
activate the feature. Throughout this document these cards are generically
referred to as ‘enable cards’. In some cases, the actual label on the physical
card may say ‘unlock’. If uncertain, the technician should verify the card part
number prior to use. Coordinate this configuration with Section 7.31 “Search
and Rescue Functional Check”.
1. With the SAR Enable card in the top slot of PFD in configuration mode, select the “SYSTEM
UPLOAD” page using the small FMS knob on PFD.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS knob to highlight “Enhanced SAR” and press ENT key on PFD.
3. Rotate the small FMS knob to select “Enhanced Search and Rescue”. Press ENT key on PFD.
4. Verify “Enhanced Search and Rescue” is displayed in the “Item” window. Press “LOAD”
softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in Configuration column for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD to acknowledge upload complete.
7. De-activate the cursor.
8. Power down the system and remove the SAR Enable card from PFD.