FAA Approved Airplane Flight Manual Supplement

Hawker Beechcraft King Air 300/300LW 190-00716-02 Rev. 3
Page 90 of 167 FAA APPROVED
OTHER PROCEDURES
GTX 3000 TRANSPONDER
For airplanes equipped with GTX 3000 Transponders:
The GTX 3000 ADS-B OUT system has been shown to meet the requirements of 14 CFR 91.227. The
ADS-B OUT system should be operational during all phases of flight, including airport surface movement
operations.
The ADS-B OUT system is operational when the active transponder is in the ON or ALT modes. This
will be indicated in the transponder window in the lower right corner of each PFD.
To place the GTX 3000 in ON or ALT Modes:
1. XPDR/TFC Softkey on PFD ................................................................................................... PRESS
2. MODE Softkey ....................................................................................................................... PRESS
3. ON or ALT Softkey ................................................................................................................. PRESS
TCAS II
For airplanes equipped with the GTS 8000 TCAS II system:
The GTS 8000 TCAS II system will normally transition between the appropriate STANDBY, TA ONLY and
TA/RA modes automatically. During airport surface movement operations, the GTS 8000 will normally
be in STANDBY Mode. The TCAS II should not be manually placed into TA ONLY or TA/RA mode
during surface movement operations.
The TCAS II should be tested as part of cockpit preparation during preflight inspection. The G1000
systems should be operating in their normal mode prior to performing a TCAS II test. A successful
TCAS test will result in the aural message “TACS II System Test Passed” being played, and no TCAS
FAIL annunciations observed on the PFDs or MFD.
To test the GTS 8000 TCAS II from the PFD:
1. XPDR/TFC Softkey on PFD ................................................................................................... PRESS
2. TCAS Softkey ......................................................................................................................... PRESS
3. TEST Softkey ......................................................................................................................... PRESS
To test the GTS 8000 TCAS II from the MFD:
1. View the MAP – TRAFFIC MAP page.
2. TEST Softkey ......................................................................................................................... PRESS
NOTE
Use of the TCAS II system test function in flight will inhibit TCAS II until the test is completed.