System Maintenance Manual

Page 3-52 G1000/GFC700 System Maintenance Manual – C90A/C90GT/C90GTi King Air
Revision F 190-00682-01
3.10 Aircraft Registration Number Entry
If not applied, apply power to the G1000 system.
1. With PFD1 in configuration mode, select the GTX page group, then select the TRANSPONDER
CONFIGURATION page on PFD1.
2. Select or verify selected, XPDR1 is in the SELECT TRANSPONDER window.
3. Ensure that the ‘ADDRESS TYPE’ is ‘US TAIL’ under the ‘SET’ and ‘ACTIVE’ columns.
4. Activate the cursor and highlight the ‘ADDRESS’ field. Use the small/large FMS knobs to enter
the aircraft registration number.
Figure 3-24. Aircraft Registration
5. Once the correct registration number is entered, press the ENT key. The transponders are
configured.
6. Press the ENT key on PFD1 to acknowledge prompt.
7. Verify FLIGHT ID TYPE = SAME AS TAIL under SET and ACTIVE columns.
8. After completing transponder configuration, deactivate the cursor.
3.11 Splash Screen Loading
When all software and configuration has been loaded, the splash screens must be loaded to all display
units (PFD1, PFD2 and MFD).
1. If not applied, apply power to the G1000 system.
2. Remove power from PFD1, PFD2 and MFD by opening the PFD1 PRI/SEC, PFD2 and MFD
circuit breakers.
3. Insert the software loader card in the upper slot of PFD2.
4. Apply power to PFD2.
5. When prompted to update system files, press the NO softkey.
6. When prompted to update splash screen files, press the YES softkey.
7. Remove the loader card from PFD2 and insert it into the upper slot of the MFD.