Pilot's Guide

190-00663-02 Rev. B
Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi
61
FLIGHT INSTRUMENTS
IfthebarometricaltimetersettingsdifferbetweenPFDsbymorethan0.02inHg,thereadoutsturnyellow.
ThesettingscanbesynchronizedfromthePFDSetupMenu.Oncethesettingsaresynchronized(BARO
SYNCturnedon),theyremainsynchronizeduntilthesettingisturnedoff.
Synchronizing the altimeter barometric pressure settings:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) If necessary, press the SETUP 1 Softkey to display the System Setup 1 Page.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the ‘Baro Sync’ in the Synchronization box.
4) Turn the small FMS Knob clockwise to ON or counterclockwise to OFF.
Figure 2-14 System Setup Page, Barometric Pressure Synchronization
Barometric Settings
not Synchronized on PFD
VERTICAL SPEED INDICATOR (VSI)
The VerticalSpeedIndicator(VSI)displaystheaircraftverticalspeedusinganon-movingtapelabeledat2000
and4000fpmwithminortickmarksevery1000fpm.Thecurrentverticalspeedisdisplayedinthepointer
alongthetape.Digitsappearinthepointerwhentheclimbordescentrateisgreaterthan100fpm.Iftherate
ofascent/descentexceeds4000fpm,thepointerappearsatthecorrespondingedgeofthetapeandtherate
appears inside the pointer.
AmagentachevronbugisdisplayedastheRequiredVerticalSpeedIndication(RVSI)forreachingaVNV
TargetAltitudeoncethe“TOD[TopofDescent]within1minute”alerthasbeengenerated.See theFlight
ManagementSectionfordetailsonVNVfeatures,andrefertoSection2.2,SupplementalFlightData,formore
informationaboutVNVindicationsonthePFD.