Pilot's Guide

190-00663-02 Rev. B
Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi
389
HAZARD AVOIDANCE
OPERATION
TheKTA870mustbeinOperatingModefortrafctobedisplayed.TheunitstartsinOperatingModeupon
power-up.
SelectingtheSTANDBY SoftkeyforcestheunitintoStandbyMode.SelectingtheNORMALSoftkeyallows
theKTA870toswitchfromStandbyModetoOperatingModeasnecessary.
Switching from operating mode to standby mode:
On the Traffic Page, select the STANDBY Softkey
Or:
1) Press the MENU Key and turn the small FMS knob to select Standby Mode.
2) Press the ENT Key.
Switching from standby mode to operating mode:
On the Traffic Page, select the NORMAL Softkey
Or:
1) Press the MENU Key and turn the small FMS knob to select Normal Mode.
2) Press the ENT Key. The KTA 870 switches from Standby Mode to Operating Mode as necessary.
System Self Test
1) Set the range to 2/6 nm to allow for full test pattern display.
2) Select the TEST Softkey.
3) Self test takes approximately eight seconds to complete. When completed successfully, traffic symbols are
displayed and a voice alert “TAS System Test OK” is heard. In the event that the system test fails, the system
reverts to Standby Mode and a voice alert “TAS System Test Fail” is heard.
Displaying traffic on the Traffic Map Page:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Select the NORMAL Softkey to begin displaying traffic. OPERATING is displayed in the Traffic mode field.
4) Select the ALT MODE Softkey to change the altitude volume.
5) Select the STANDBY Softkey to place the system in the Standby mode. STANDBY is displayed in the Traffic
mode field.
6) Turn the RANGE Knob clockwise to display a larger area or counter-clockwise to display a smaller area.