Pilot's Guide

190-00663-02 Rev. B Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi 124
AUDIO PANEL AND CNS
Figure 4-30 Transponder Softkeys (PFD)
Selecting the BACK Softkey
returns to the top-level softkeys.
ALERTS
ALERTS BACK BKSP
IDENT
7 6 5 4 3 2 1 0
STBY ON
ALT VFR
CODE
IDENT BACK
XPDR
IDENT
Selecting the BACK Softkey returns to the mode selection softkeys.
GND
XPDR1
XPDR2
ADS-B TX
Selecting and activating Transponder 1 or Transponder 2:
1) Select the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Select the XPDR1 or XPDR2 Softkey to select and activate the desired transponder.
WhenpoweringontheG1000,thesystemactivatesTransponder1asthedefaultunit,regardlessofwhich
transponderwasactivepriortoshutdown.WhenswitchingbetweenTransponder1andTransponder2,the
codeandmoderemainthesame.Ifanewcodeisenteredintheactivetransponder,switchingtransponders
does not bring back the previous code.
TRANSPONDER MODE SELECTION
Mode selection can be automatic (Ground and Altitude Modes) or manual (Standby, ON, and Altitude Modes).
The STBY , ON, and ALT Softkeys can be accessed by selecting the XPDR Softkey.
Selecting a transponder mode:
1) Select the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Select the desired softkey to activate the transponder mode.