Pilot's Guide

190-00663-02 Rev. B Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi 122
AUDIO PANEL AND CNS
DME TUNING
NOTE: When turning on the G1000 for use, the system remembers the last frequency used for DME tuning
and the NAV1 , NAV2, or HOLD state prior to shutdown.
TheG1000SystemtunestheoptionalDMEtransceiver.TunetheUHFDMEfrequencybypairingwithaVHF
NAVfrequency.DMEfrequencypairingisautomaticandonlytheVHFNAVfrequencyisshown.
TheDMETuningWindowislocatedtotherightoftheHSIinthelowerrightcornerofthePFD.SelectNAV1,
NAV2,orHOLDintheDMETuningWindowtotunetheDMEtransceiver.Pressingthe DME Softkey shows
orhidestheDMETuningWindow.
Figure 4-29 DME Tuning Window
DME
Modes
ThefollowingDMEtransceiverpairingcanbeselected:
•NAV1–PairstheDMEfrequencyfromtheselectedNAV1frequency.
•NAV2–PairstheDMEfrequencyfromtheselectedNAV2frequency.
•HOLD – When in the HOLD position, the DME frequency remains paired with the last selected NAV
frequency.
Selecting DME transceiver pairing:
1) Press the DME Softkey to display the DME Tuning Window.
2) Turn the small FMS Knob to select the DME tuning mode.
3) Press the ENT Key to complete the selection.
Pressing the CLR Key or FMSKnobwhileintheprocessofDMEpairingcancelsthetuningentryandreverts
backtothepreviouslyselectedDMEtuningstate.PressingtheFMS Knob activates/deactivates the cursor in
theDMETuningWindow.
SeetheFlightInstrumentsSectionfordisplayingtheDMEinformationwindow.